3. See the options,
which you have chosen and confirmed them on the “Summary
of Selections” page.
4. Install the DNS and run the “Configure
a DNS” wizard for DNS configurations. Click
“next” if the summary of selection”
page lists these two items. Click “back”
to move to “Server Role” page, if the
“summary of selections” page did not list
these two items.
5. “Configure your server”
wizard first determines the IP address for this server
to find whether it is static or is configured automatically,
when it installs the DNS service. The “Configuration
Components” page of windows components Wizard
prompt will prompt you to configure the server using
static IP address if you are using automatic IP addressing.
In order to do this
• Click the “internet
protocol” then click “properties”
in the “Local Area Connection Properties”.
• Now click the “Use the following IP
address” in the “internet protocols
properties” dialog box.
• Type the IP address of this server in “Preferred
DNS”.
• Now type the IP address of another internal
DNS server in “Alternate DNS”. You may
leave it blank.
• Click “OK” when you have finished
setting up the static addresses for your DNS then
click “close”.
6. After clicking “close”, DNS server
wizard will be started. Now follow these steps
• Choose the “create
a forward lookup zone” from “select
Configuration Action” page.
• Click “this server maintains the zone”
and then click “next”
• Specify the name of the DNS zone for your
network on the “zone name” page and
in “zone name” then click “next”.
• Now click the “allow both non secure
and secure dynamic updates” on the “forwarders”
page and click “next”.
• Click "back” if you want to change
any setting. Finally click “Finish”
to apply you selections.
DNS has been successfully configured
|